Technical Support - Dash

INSTALLATION GUIDES

FAQ's

Do you do a version for the Voyager Pro

Yes ! It supports both standard and aluminum docks and can be mounted using AMPS mounts or vehicle specific kits.

Can you access the MicroSD Card?

Dash

Access to the memory card is by lifting the Voyager out of the Dash. Quick Release thumb screws make this a quick and easy operation only requiring you to release one side of the mask and requiring no tools. Several prototypes were produced with access holes in the case of the Dash but were felt to be impractical as access was still tight and with the card being so small likely to result in much frustration and dropped/lost cards.

Pro Dash

Access to the SD Card is via removal of the bezel and ejecting the Voyager unit from the dock.

Will it fit earlier bikes than 2021?

The Dash has been installed on a 2017 which is the same as the 2015 and 2016 with no modifications. Please review the installation guide for photos.

Can I use it with bar risers?

Yes, please review the compatibility chart available on the product page.

Where is the product manufactured and shipped from?

The Dash is designed, manufactured and shipped from Houston, TX

What is it made from?

The Dash is made from 6061 Aluminum and anodized to Mil Spec. MIL-A-8625 Type II Class 2

Is everything I need included?

The Dash includes fasteners, mounting bracket, spacers and a replacement electrical panel. Optional accessories are available including USB Outlet, wiring kit and ready made harness. The USB hole will fit any of the round outlets that can be found on Amazon. It’s 29.5mm diameter. 

Can I install a switch for my heated grips?

Yes, there's a 1/2" (12.7mm) accessory mounting hole on the left side which will accommodate a switch of your choice.

Will you do custom modifications?

Just ask, always looking to enhance the product by understanding what people need. Custom work will obviously have a shipping time impact and may incur additional cost.